DaVinci MIQRO Flat Mouthpiece Zirconia

Additional information about DaVinci MIQRO Flat Mouthpiece Zirconia

Table of Contents

• You Should Buy the MIQRO Flat Mouthpiece Zirconia If…
• How to Replace the Mouthpiece
• Why This One's Zirconia, Not Silicone
• Cleaning the Mouthpiece
• Compatibility

You Should Buy the MIQRO Flat Mouthpiece Zirconia If…

You should buy the MIQRO Flat Mouthpiece Zirconia if your stock one is chipped, cracked, or lost. The MIQRO C is NOT compatible with this mouthpiece, so its main use is as a quick replacement for those who already own a Davinci MIQRO.

How to Replace the Mouthpiece

The mouthpiece is extremely easy to setup and works exactly the same as the default piece that comes with the MIQRO.

Here's a step-by-step guide to fit the new mouthpiece on the MIQRO:

• Step 1: Power off the MIQRO and remove the old mouthpiece from the top cap.
• Step 2: Press the new mouthpiece into the same opening until it sits flush.
• Step 3: Power the MIQRO back on and run your session as usual.

Why This One's Zirconia, Not Silicone

The original MIQRO's stock mouthpiece is zirconia, matching the zirconium vapor path beneath it, while the MIQRO-C switched to a silicone mouthpiece for the same job. Keeping the mouthpiece the same material as the vapor path means there's no material transition right where vapor cools last, so the flavor stays neutral. Overall, the zirconia makes the experience much better (for flavor) than if it was silicone based.

Cleaning the Mouthpiece

Rinse the mouthpiece under warm water after each session to prevent residue from building up. For a deeper clean, wipe it down with isopropyl alcohol on a cotton swab, then rinse and dry it fully before putting it back on the device.

Compatibility

• Davinci MIQRO