Tronian Omegatron 2 BurstHit All Wall Heating Chamber

Additional information about Tronian Omegatron 2 BurstHit All Wall Heating Chamber

Table of Contents

• You Should Buy the BurstHit All Wall Heating Chamber If…
• How to Install the BurstHit All Wall Heating Chamber
• Getting the Best Vapor from All Wall Heating
• Cleaning and Replacing the BurstHit All Wall Heating Chamber
• Compatibility

You Should Buy the BurstHit All Wall Heating Chamber If…

You should buy the Tronian Omegatron 2 BurstHit All Wall Heating Chamber if you're replacing a spent atomizer or want a few spares on hand so you can swap in a clean chamber for a fresh session and leave the cleaning for later.

How to Install the BurstHit All Wall Heating Chamber

The BurstHit All Wall Heating Chamber screws into the Omegatron 2’s base. It's one of the main ways to use the Omegatron 2.

Here is a step by step guide to use Wax with the Omegatron 2:

Step 1: Remove the glass cup and silicone cover from the Omegatron 2’s base.

Step 2: Unscrew any 510 cartridges or heating chamber currently in the base, if there is one.

Step 3: Screw the new BurstHit All Wall Heating Chamber into the Omegatron 2’s base, then place the silicone wax cover (with the metal tube) and glass cup back on the base.

Getting the Best Vapor from All Wall Heating

Before using a new BurstHit All Wall Heating Chamber for the first time, run one full heat cycle on the highest setting with the chamber empty to burn off any oils left over from manufacturing. After that, the best vapor comes from small loads. Keep each one to 0.05 to 0.1g, about the size of a grain of rice, and place it in the middle of the ceramic bucket.

It is recommended to use a heated dab tool such as the Utillian Hot Wax Axe to ensure all of your wax sits in the center of the chamber for better vaporization. How long a load lasts depends on your temperature. For stronger, denser vapor, use higher temperatures; for smoother, fluffier vapor, use lower temperatures.

Cleaning and Replacing the BurstHit All Wall Heating Chamber

To clean the BurstHit All Wall Heating Chamber, you can do it after every session with a cotton swab soaked in isopropyl alcohol. Let the chamber cool, wipe out the ceramic bucket, and let it dry completely before your next session. Keep water away from it and never submerge it. Over time, residue bakes onto the walls of the bucket. When that char no longer comes off with a swab, it's time for a new chamber.

Compatibility

Tronian Omegatron 2