Tronian Omegatron Heating Chamber Cover Pack

Additional information about Tronian Omegatron Heating Chamber Cover Pack

Table of Contents

• You Should Buy the Omegatron 2 Heating Chamber Cover Pack If…
• How to Fit the Heating Chamber Covers
• When to Replace Your Heating Chamber Covers
• Cleaning Your Heating Chamber Covers
• Compatibility

You Should Buy the Omegatron 2 Heating Chamber Cover Pack If…

You need to replace a worn or lost cover, or you want a spare set on hand so your session doesn't have to wait while one is being cleaned. The pack comes with both covers, one for wax and one for 510 carts, so you have what you need whichever way you use your Omegatron 2.

How to Fit the Heating Chamber Covers

Each cover goes on after your heating chamber is loaded or your 510 cartridge is screwed in, and the glass cup then sits over it. Here is a step-by-step guide to fit the cover correctly:

• Make sure the device has cooled down, then lift the glass cup off the base.
• Take off the old cover.
• Pick the cover that matches what's screwed into the base. The cover with the metal tube goes over the heating chamber, and the cover with the slits on top goes over a 510 cartridge.
• Place the cover over the chamber or cartridge, then set the glass cup back on the base.

Pro Tips: The two covers look almost the same from the side, so check the top if you're not sure which one you're holding. The wax cover has a round opening where the metal tube comes through, and the 510 cover has slits.

If you're using wax, load your concentrate before the cover goes on.

When to Replace Your Heating Chamber Covers

The covers do more than sit on top of the chamber. The wax cover has ridges on the bottom that spin the air coming in to create a vortex airflow, which keeps your wax moving around the chamber so it heats more efficiently, and its metal tube carries your vapor up into the glass. The 510 cover has slits that open around your cartridge, so the vapor can come straight out of the cart.

They're wear and tear parts, so replacing them from time to time is a normal part of owning an Omegatron 2. You might not ever have to replace them if you take good care of them.

If your sessions aren't what they used to be and your heating chamber is clean, check the cover next. If you notice any slits or vapor during the heating, before it reaches the glass, it may be time to replace the heating chamber cover.

Cleaning Your Heating Chamber Covers

The covers sit right above the heat, so they pick up residue over time. After your session, let the cover cool, then wipe it down with an alcohol wipe. On the wax cover, pay extra attention to the ridges on the bottom and the inside of the metal tube, since they move the air and carry your vapor.

We recommend quick wipes and cleaning periodically rather than waiting for it to gunk up and then submerging your silicone.

Compatibility

• Tronian Omegatron 2