DaVinci EQ Jacuzzi Bubbler

Additional information about DaVinci EQ Jacuzzi Bubbler

Table of Contents

• You Should Buy the Davinci EQ Jacuzzi Bubbler If…
• How to Fill and Attach the Jacuzzi Bubbler
• 60ml Water Chamber for Vapor Cooling
• Borosilicate Glass and Magnetic Connection
• Cleaning the Jacuzzi Bubbler
• Compatibility

You Should Buy the Davinci EQ Jacuzzi Bubbler If…

You should buy the Davinci EQ Jacuzzi Bubbler if your EQ's original bubbler is cracked, chipped, or clouded with reclaim you can't fully clean out, or if you simply want a fresh one on hand so a session is never held up by cleaning.

How to Fill and Attach the Jacuzzi Bubbler

The Jacuzzi Bubbler is a magnetic drop-in piece, so there's no threading or twisting involved. Here is the step by step guide on how to use it:

• Lift the bubbler off the EQ base by pulling it straight up with enough force to surpass the magnetic connection.
• Fill the bubbler with water, up to about 60ml or roughly a quarter cup. Fill no more than halfway up the chamber.
• Set the bubbler back onto the base and let the magnets pull it into place. You should feel it seat with a light snap.
• Attach your mouthpiece and carb injector cap, then run your session as usual.

60ml Water Chamber for Vapor Cooling

At 60ml, the Jacuzzi Bubbler holds noticeably more water than the small percolators bundled with most portable e-rigs, and that extra volume is the whole point. More water means more surface area and contact time for vapor to pass through. The Glass is also made of borosilicate glass, which is a staple for great vapor.

Borosilicate Glass and Magnetic Connection

The Jacuzzi Bubbler is made of borosilicate glass and uses a magnetic connection for quick, secure attachment to the EQ base. The magnetic drop-in design means there is no threading or twisting required.

Cleaning the Jacuzzi Bubbler

Empty the bubbler after every session rather than letting water sit, as stagnant water picks up odors and tastes more quickly. For a deeper clean, remove the mouthpiece, add isopropyl alcohol with a bit of coarse salt, and swirl or gently shake to break up buildup on the glass walls (make sure you remove the bubbler before cleaning). Letting it sit in a sealed bag for a few minutes gives the alcohol more time to work before you rinse. Always rinse thoroughly with clean water afterward so no solvent residue is left before your next fill.

Compatibility

• Davinci EQ Electric Dab Rig Base