DaVinci EQ Zirconia Crucible

Additional information about DaVinci EQ Zirconia Crucible

Table of Contents

• You Should Buy the Davinci EQ Zirconia Crucible If…
• How to Install the Zirconia Crucible
• Quartz vs. Zirconia: What Actually Changes
• Cleaning the Zirconia Crucible
• Compatibility

You Should Buy the Davinci EQ Zirconia Crucible If…

You should buy the Davinci EQ Zirconia Crucible if you run heavy, back-to-back sessions and want a chamber that holds its heat between draws, or if your current crucible is cracked, worn, or coated in reclaim that won't come off.

How to Install the Zirconia Crucible

The Davinci EQ is modular in design, so installing the Crucible is easy, but requires a few moving parts.

Here's how to install the Zirconia Crucible:

• Power off the EQ and unscrew the retention ring to remove the old crucible and O-ring.
• Place the new Zirconia3 Crucible onto the heater.
• Place the O-ring back on and screw the retention ring down until snug.
• Power on the Davinci EQ and start your sessions as usual.

Zirconia vs. Quartz: What Actually Changes

Zirconia is a dense material, it is basically a high quality ceramic that holds heat well and is not as porous as ceramic, so vapor stays cleaner for longer. Its also less prone to chipping or breaking, therefore its a better option for users who want to extend the time where a crucible replacement is needed.

Quartz is slightly better for people who want straightforward, flavorful vapor. It's also see-through, which makes it a good option for users who want to see the vapor generation.

Cleaning the Zirconia Crucible

Swab out the crucible while it's still warm from your last session, since residue comes off zirconia more easily when it's warm than once it's cooled and hardened. For a deeper clean, remove the crucible from the heater and soak it in isopropyl alcohol(20-30 minutes), then rinse and dry it fully before putting it back on.

Compatibility

• Davinci EQ E Rig